Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO ANTENNA › 2012.01–2012.04
RM1840EF _56 Audio / Visual / Telematics _009631 AUDIO / VIDEO _0052650 RADIO ANTENNA A

AUDIO / VIDEO  RADIO ANTENNA  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 4.REMOVE ANTENNA WITH HOLDER ASSEMBLY

a.
E227755

Disconnect the connector.


b.

Remove the 2 screws and detach the clamp.


c.

Remove the antenna as shown in the illustration.

HINT:

Fully extend the antenna pole before removing the antenna with holder assembly.