1.INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY (for Double Cab)
Attach the 9 clamps to install the antenna cord.
Connect the 2 connectors.
2.INSTALL ROOF HEADLINING ASSEMBLY
3.INSTALL ANTENNA CORD SUB-ASSEMBLY
w/ Roof Antenna:
Install the antenna cord with the clamp bolt.
Attach the 6 clamps.
Connect the connector.
w/o Roof Antenna:
Attach the 4 clamps shown in the illustration to install the antenna cord.
Connect the connector.
4.INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY
5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
6.CHECK SRS WARNING LIGHT