Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO ANTENNA CORD › 2012.01–2012.04
RM1840EF _56 Audio / Visual / Telematics _009631 AUDIO / VIDEO _0052651 RADIO ANTENNA CORD A

AUDIO / VIDEO  RADIO ANTENNA CORD  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 4.REMOVE ANTENNA CORD SUB-ASSEMBLY

a.

w/o Roof Antenna:

i.

Disconnect the connector.

E225164


ii.

Detach the 4 clamps shown in the illustration. Then remove the antenna cord.



b.

w/ Roof Antenna:

i.

Disconnect the connectors.

E225165


ii.

Detach the 6 clamps shown in the illustration.


iii.

Remove the clamp bolt and antenna cord.



Hide 6.REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY (for Double Cab)

a.

Disconnect the 2 connectors.


b.

Detach the 9 clamps and remove the antenna cord.

E225198