Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
1.INSTALL REAR SPEAKER ASSEMBLY
Hold the speaker to the panel.
Install the speaker with the 3 screws.
Connect the connector.
2.INSTALL QUARTER INSIDE TRIM BOARD LH
3.INSTALL FRONT DOOR OPENING TRIM LH
4.INSTALL FRONT DOOR SCUFF PLATE LH
5.INSTALL REAR SEATBACK ASSEMBLY
6.INSTALL LOWER BACK PANEL GARNISH
7.INSTALL REAR SEAT CUSHION ASSEMBLY LH (w/ Seat Cushion)
8.INSTALL REAR SEAT CUSHION ASSEMBLY RH (w/ Seat Cushion)
9.INSTALL UPPER BACK PANEL GARNISH
10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).