A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
1.INSTALL NO. 2 RADIO BRACKET
Install the No. 2 radio bracket to the navigation receiver with the 3 screws.
2.INSTALL NO. 1 RADIO BRACKET
Install the No. 1 radio bracket to the navigation receiver with the 3 screws.
3.INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET
Connect all the connectors and insert the navigation receiver assembly with bracket.
Install the navigation receiver assembly with bracket with the 4 screws.
4.INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).