This circuit includes the parking brake switch and navigation receiver assembly.
Display the "Connection Status" screen.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>OPERATION CHECK
Check that the display changes between On and Off according to the parking brake operation.
| Parking Brake Condition | Display |
|---|---|
| Applied | On |
| Released | Off |
This display is updated once per second. As a result, it is normal for the display to lag behind the actual parking brake operation.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE
NG
Disconnect the G153 navigation receiver assembly connector.
Disconnect the K6 parking brake switch assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G153-6 (PKB) - K6-1 | Always | Below 1 Ω |
| G153-6 (PKB) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
|
On |
|
Off |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| Switch connector terminal - Switch body | On (Shaft not pressed) | Below 1 Ω |
| Off (Shaft pressed) | 10 kΩ or higher |
If the result is not as specified, replace the parking brake switch assembly.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE
NG