Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › 2012.01–2012.04
RM1840EF _56 Audio / Visual / Telematics _009632 NAVIGATION / MULTI INFO DISPLAY _0052661 NAVIGATION SYSTEM C

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  B15C2  Speed Signal Malfunction  


DESCRIPTION

The navigation receiver assembly receives a vehicle speed signal from the combination meter assembly and information about the navigation antenna, and then adjusts the vehicle position.

The navigation receiver assembly stores this DTC when the difference between the speed information that the navigation antenna receives and the SPD pulse received from the combination meter assembly becomes large.

HINT:
·

A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter assembly. The signal is changed to a pulse signal at the transistor in the combination meter assembly. Each ECU controls the respective systems based on the pulse signal.

·

If a short occurs in any of the ECUs or in the wire harness connected to an ECU, all systems in the diagram below will not operate normally.



DTC No. Detection Item DTC Detection Condition Trouble Area
B15C2 Speed Signal Malfunction A difference between the GPS speed and SPD pulse is detected.
·

Harness or connector

·

Combination meter assembly

·

Navigation receiver assembly



WIRING DIAGRAM

E238676
0.927,1.563 1.229,1.719 0.302,0.156 10 false G19 0.927,1.719 2.094,2.094 1.167,0.375 10 false Combination Meter Assembly 5.031,1.563 5.396,1.719 0.365,0.156 10 false G152 3.125,1.552 4.156,1.708 1.031,0.156 10 false to Related ECU 5.208,0.99 5.573,1.146 0.365,0.156 10 false SPD 1.802,0.99 2.01,1.146 0.208,0.156 10 false +S 2.083,0.865 2.292,1.021 0.208,0.156 10 false 6 4.938,0.865 5.115,1.021 0.177,0.156 10 false 17 5.031,1.719 6.24,2.125 1.208,0.406 10 false Navigation Receiver Assembly

PROCEDURE

1.CHECK VEHICLE SENSOR (OPERATION CHECK)

b.

While driving the vehicle, check that the value and gauge change in response to changes in vehicle speed.

OK:

The value and gauge change in response to changes in vehicle speed.



Result:
Proceed to
OK
NG



OK

NG