1.INSTALL REAR TELEVISION CAMERA ASSEMBLY
Attach the 2 guides as shown in the illustration.
Make sure that each guide is attached to its corresponding rail.
Attach the 2 claws to install the rear television camera assembly.
Visually check that the guides and claws are attached to the back door No. 2 outside garnish.
2.INSTALL BACK DOOR NO. 2 OUTSIDE GARNISH
Attach the claw and 2 guides as shown in the illustration.
Attach the 2 claws to install the back door No. 2 outside garnish.
| *1 | Tail Gate Lock Control Link |
Connect the connector.
Make sure that the wire harness is between the tail gate inner panel and tail gate lock control link.
3.INSTALL TAIL GATE SERVICE HOLE COVER