A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
1.INSTALL TAIL GATE HINGE ASSEMBLY LH
| *1 | "TORX" Bolt |
| *2 | Bolt |
Install the tail gate hinge with the bolt.
Using a T40 "TORX" socket wrench, install the 2 "TORX" bolts.
2.INSTALL TAIL GATE HINGE ASSEMBLY RH
Use the same procedure described for the LH side.
3.INSTALL TAIL GATE STAY STOPPER (for A Deck)
Use the same procedure for both tail gate stay stoppers.
Install the tail gate stay stopper with the bolt.
4.INSTALL TAIL GATE LOCK ASSEMBLY LH (for A Deck)
Install the tail gate lock with the 2 bolts.
5.INSTALL TAIL GATE LOCK ASSEMBLY RH (for A Deck)
Use the same procedure described for the LH side.
6.INSTALL TAIL GATE HANDLE ASSEMBLY (for A Deck)
Install the tail gate handle with the 2 bolts.
7.INSTALL TAIL GATE LOCK CONTROL LINK LH (for A Deck)
| *1 | Snap |
Install the tail gate lock control link.
Rotate the control link snaps in the directions indicated by the arrows in the illustration and attach the control link snaps to the tail gate lock control link.
8.INSTALL TAIL GATE LOCK CONTROL LINK RH (for A Deck)
Use the same procedure described for the LH side.
9.INSTALL REAR BODY TAIL GATE LATCH ASSEMBLY (for J Deck)
Use the same procedure for both rear body tail gate latches.
Install the rear body tail gate latch with the 2 bolts.
10.INSTALL REAR TELEVISION CAMERA ASSEMBLY (w/ Rear View Monitor System)
11.INSTALL BACK DOOR NO. 2 OUTSIDE GARNISH (w/ Rear View Monitor System)
12.INSTALL CENTER STOP LIGHT ASSEMBLY (w/ Center Stop Light)
13.INSTALL TAIL GATE SERVICE HOLE COVER
for A Deck:
Install the tail gate service hole cover with the 10 screws.
for J Deck:
Install the tail gate service hole cover with the 8 screws.