1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.REMOVE V-BANK COVER
4.REMOVE FAN AND GENERATOR V BELT
5.REMOVE GENERATOR ASSEMBLY
Disconnect the terminal cap.
Disconnect the generator connector.
Remove the 2 bolts and nut, and then disconnect the generator wire.
Remove the 2 bolts and generator.