These DTCs are stored when a malfunction occurs in the instrument panel integration antenna assembly (telephone antenna) circuit.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B1573 | Short in Telephone Antenna Circuit | There is a short circuit in the telephone antenna between the telephone transceiver assembly and instrument panel integration antenna assembly, or at the points where it connects to the telephone transceiver assembly and instrument panel integration antenna assembly. | ·
Telephone transceiver assembly ·
Instrument panel integration antenna assembly (telephone antenna) |
| B15CB | Telematics Transceiver Antenna Disconnected | There is an open circuit in the telephone antenna between the telephone transceiver assembly and instrument panel integration antenna assembly, or at the points where it connects to the telephone transceiver assembly and instrument panel integration antenna assembly. | ·
Telephone transceiver assembly ·
Instrument panel integration antenna assembly (telephone antenna) |
When replacing the telephone transceiver assembly or instrument panel integration antenna assembly, refer to the Service Bulletin.
When the telephone transceiver assembly is replaced, it is necessary to set the contract mode.
Turn the ignition switch off.
Check that the connectors are properly connected to the telephone transceiver assembly and instrument panel integration antenna assembly (telephone antenna connector).
Connectors are properly connected.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>BLOCKING SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>BLOCKING SYSTEM>DTC CHECK / CLEAR
DTC B1573 or B15CB is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the instrument panel integration antenna assembly (telephone antenna) connector [color: wine red].
Check that the connector pins are not bent.
Connector pins are not bent.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *1 | Core wire |
| *2 | Shield |
Disconnect the instrument panel integration antenna assembly (telephone antenna) connector [color: wine red].
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Core wire - Shield | Always | 4 to 11 kΩ |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>BLOCKING SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
Wiggle the instrument panel integration antenna assembly (telephone antenna).
Check for the DTCs.
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>BLOCKING SYSTEM>DTC CHECK / CLEAR
DTC B1573 or B15CB is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Temporarily replace the instrument panel integration antenna assembly with a new or normally functioning one (Refer to the Service Bulletin).
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>BLOCKING SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>BLOCKING SYSTEM>DTC CHECK / CLEAR
DTC B1573 or B15CB is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG