Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SPIRAL CABLE › 2011.10–2012.04
RM1840EF _58 Vehicle Interior _009645 SUPPLEMENTAL RESTRAINT SYSTEMS _0052711 SPIRAL CABLE A

SUPPLEMENTAL RESTRAINT SYSTEMS  SPIRAL CABLE  INSTALLATION  


PROCEDURE

Hide 1.INSTALL SPIRAL CABLE SUB-ASSEMBLY

a.

Attach the 3 claws to install the spiral cable sub-assembly.

NOTICE:

When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel assembly.



b.

Remove the stopper (new spiral cable).

HINT:

When installing a new spiral cable make sure to remove the stopper.



c.

Connect the connectors.

NOTICE:

When handling the airbag connector, do not damage the airbag wire harness.



Hide 4.ADJUST SPIRAL CABLE SUB-ASSEMBLY (REUSE ONLY)

a.

Turn the ignition switch off.


b.

Disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.
B277382

Rotate the spiral cable sub-assembly with steering sensor counterclockwise slowly by hand until it feels firm.

NOTICE:

Do not use the airbag wire harness to turn the spiral cable sub-assembly.



d.
B278684
3.063,0.667 2.917,0.667 false 2.917,0.667 2.604,1.25 false 2.917,0.667 2.625,1.458 false 3.073,0.573 3.375,0.75 0.302,0.177 10 *a
*a Mark


Rotate the spiral cable sub-assembly clockwise approximately 2.5 turns to align the marks.

NOTICE:

Do not turn the spiral cable with steering sensor by the airbag wire harness.


HINT:

The spiral cable with steering sensor can be rotated approximately 2.5 turns to both the left and right from the center position.



Hide 5.INSTALL LOWER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 6.INSTALL STEERING WHEEL ASSEMBLY