A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
1.INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
for Automatic Air Conditioning System:
Connect the room temperature sensor.
Attach the 2 guides to install the lower instrument panel.
Connect the connectors and attach the clamps.
Connect the hood lock control cable, fuel lid lock control cable and DLC3.
Install the 2 bolts <C>, nut <D> and 3 screws <E>.
Install the 2 clips <B>.
| *1 | Clip <B> | *2 | Bolt <C> |
| *3 | Nut <D> | *4 | Screw <E> |
| *5 | Hood Lock Control Cable | *6 | Fuel Lid Lock Control Cable |
| *7 | DLC3 | *8 | Clamp |
| *9 | Guide | - | - |
2.INSTALL NO. 1 SWITCH HOLE BASE
Attach the 5 claws to install the No. 1 switch hole base.
3.INSTALL SWITCH BASE
Connect the connectors.
Attach the 8 claws to install the switch base.
4.INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY (w/o Front Passenger Airbag)
5.INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL (w/o Console Box, w/o Console Box Lid)
Attach the 3 claws to install the lower center instrument panel finish panel.
Install the 2 clips <B>.
6.INSTALL AIR CONDITIONER CONTROL ASSEMBLY (for Manual Cooler System)
7.INSTALL NO. 1 INSTRUMENT PANEL BOX
Connect the connectors and attach the clamp.
Install the No. 1 instrument panel box with the 6 screws <A>.
8.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
Attach the 3 guides, 2 claws and 3 clips to install the lower instrument panel finish panel.
9.INSTALL NO. 3 HEATER TO REGISTER DUCT
10.INSTALL NO. 1 HEATER TO REGISTER DUCT
11.INSTALL NO. 2 HEATER TO REGISTER DUCT
12.INSTALL COWL SIDE TRIM BOARD LH
Attach the 2 clips to install the cowl side trim board.
Install the clip.
Install the front door opening trim.
13.INSTALL COWL SIDE TRIM BOARD RH
Use the same procedure described for the LH side.
14.INSTALL FRONT DOOR SCUFF PLATE LH
for Double Cab:
(See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Double Cab)>INSTALLATION)
for Single Cab:
(See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Single Cab)>INSTALLATION)
15.INSTALL FRONT DOOR SCUFF PLATE RH
Use the same procedure described for the LH side.
16.INSTALL CONSOLE BOX ASSEMBLY (w/ Console Box Lid)
17.INSTALL HEADLIGHT DIMMER SWITCH ASSEMBLY
18.INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY
19.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Airbag System)
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
20.CHECK SRS WARNING LIGHT (w/ Airbag System)