Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SPIRAL CABLE
RM1840EF _58 Vehicle Interior _009645 SUPPLEMENTAL RESTRAINT SYSTEMS _0052711 SPIRAL CABLE G

SUPPLEMENTAL RESTRAINT SYSTEMS  SPIRAL CABLE  INSPECTION  


PROCEDURE

Hide 1.INSPECT SPIRAL CABLE SUB-ASSEMBLY

a.

If there are any defects as mentioned below, replace the spiral cable with a new one:

Scratches, cracks, dents or chips in the connector or spiral cable.


b.
B342440
0.813,1.729 1.021,1.917 0.208,0.188 1.729,0.948 1.948,1.135 0.219,0.188 2.292,0.948 2.51,1.135 0.219,0.188 1.25,4.104 1.646,4.292 0.396,0.188 2.24,4.104 2.635,4.292 0.396,0.188 0.521,1.021 0.833,1.177 0.313,0.156 10 false *a 1.802,0.958 2.115,1.115 0.313,0.156 10 false B 0.875,1.74 1.188,1.896 0.313,0.156 10 false A 2.354,0.969 2.667,1.125 0.313,0.156 10 false C 1.313,4.115 1.625,4.271 0.313,0.156 10 false G12 2.302,4.125 2.615,4.281 0.313,0.156 10 false G52
*a Orange


Check the spiral cable.

i.

Set the spiral cable to the center position (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>INSTALLATION).


ii.

After setting the spiral cable to the center position, rotate the spiral cable 2.5 times counterclockwise, and measure the resistance as shown. Then rotate the spiral cable 5 times clockwise, and measure the resistance as shown.

Standard Resistance:
Tester Connection Condition Specified Condition
G52-1 - A-2 Always Below 1 Ω
G52-2 - A-1 Always Below 1 Ω
G12-6 - B-10 Always Below 1 Ω
G12-5 - B-9 Always Below 1 Ω
G12-4 - B-8 Always Below 1 Ω
G12-3 - B-7 Always Below 1 Ω
G12-2 - B-6 Always Below 1 Ω
G12-2 - C-4 Always Below 1 Ω
G12-1 - C-3 Always Below 1 Ω
G12-12 - B-5 Always Below 1 Ω
G12-11 - B-4 Always Below 1 Ω
G12-10 - B-3 Always Below 1 Ω
G12-9 - B-2 Always Below 1 Ω
G12-8 - B-1 Always Below 1 Ω
G12-8 - C-2 Always Below 1 Ω
G12-7 - C-1 Always Below 1 Ω



iii.

After setting the spiral cable to the center position, rotate the spiral cable 2.5 times clockwise. Then while rotating the spiral cable 5 times counterclockwise, measure the resistance as shown.

Standard Resistance:
Tester Connection Condition Specified Condition
G52-1 - A-2 Always Below 1 Ω
G52-2 - A-1 Always Below 1 Ω
G12-6 - B-10 Always Below 1 Ω
G12-5 - B-9 Always Below 1 Ω
G12-4 - B-8 Always Below 1 Ω
G12-3 - B-7 Always Below 1 Ω
G12-2 - B-6 Always Below 1 Ω
G12-2 - C-4 Always Below 1 Ω
G12-1 - C-3 Always Below 1 Ω
G12-12 - B-5 Always Below 1 Ω
G12-11 - B-4 Always Below 1 Ω
G12-10 - B-3 Always Below 1 Ω
G12-9 - B-2 Always Below 1 Ω
G12-8 - B-1 Always Below 1 Ω
G12-8 - C-2 Always Below 1 Ω
G12-7 - C-1 Always Below 1 Ω


NOTICE:

As the spiral cable may break, do not rotate the spiral cable more than the specified amount.