Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY › 2012.01–2012.04
RM1840EF _58 Vehicle Interior _009645 SUPPLEMENTAL RESTRAINT SYSTEMS _0052712 FRONT PASSENGER AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT PASSENGER AIRBAG ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 1.INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

a.

Attach the 12 claws to install the instrument panel passenger airbag assembly.


b.

Attach the clamp to the bracket.


c.

Install the 2 bolts.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


d.

Connect the connector.

NOTICE:

When handling the airbag connector, do not damage the airbag wire harness.



Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).