Wear protective gloves. Sharp areas on the parts may injure your hands.
1.INSTALL FRONT SEAT ASSEMBLY
Place the front seat assembly in the cabin.
Be careful not to damage the vehicle body.
Connect the seat wire connector under the seat.
Connect the cable to the negative (-) battery terminal.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
Temporarily install the front seat assembly with the 4 bolts.
Operate the power seat switch (slide switch) to move the seat to the rearmost position.
Tighten the bolts in the order shown in the illustration.
Operate the power seat switch (slide switch) to move the seat to the foremost position.
Tighten the bolts in the order shown in the illustration.
2.INSTALL SEAT TRACK COVER LH
Attach the 2 claws in the order shown in the illustration to install the seat track cover LH.
Be careful not to damage the claws.
3.INSTALL INNER SEAT TRACK BRACKET COVER LH
Attach the 2 claws in the order shown in the illustration to install the inner seat track bracket cover LH.
Be careful not to damage the claws.
4.INSTALL FRONT SEAT HEADREST ASSEMBLY
Install the front seat headrest assembly.
5.INSPECT FRONT SEAT ASSEMBLY