Wear protective gloves. Sharp areas on the parts may injure your hands.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.REMOVE FRONT SEAT HEADREST ASSEMBLY
Remove the front headrest assembly.
3.REMOVE INNER SEAT TRACK BRACKET COVER LH
Operate the power seat switch (slide switch) to move the seat to the foremost position.
Using a moulding remover, detach the 2 claws and remove the inner seat track bracket cover LH.
4.REMOVE SEAT TRACK COVER LH
Using a moulding remover, detach the 2 claws and remove the seat track cover LH.
5.REMOVE FRONT SEAT ASSEMBLY
Remove the 2 bolts.
Operate the power seat switch (slide switch) to move the seat to the rearmost position.
Remove the 2 bolts.
Operate the power seat switch (slide switch) and move the seat to the center position, operate the power seat switch (reclining switch) and move the seatback to the upright position, and operate the power seat switch (lifter switch) and move the seat to the uppermost position.
Disconnect the cable from the negative (-) battery terminal.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
Disconnect the connector under the seat.
Remove the front seat assembly from the vehicle.
Be careful not to damage the vehicle body.