Wear protective gloves. Sharp areas on the parts may injure your hands.
1.REMOVE FRONT SEAT ASSEMBLY
2.REMOVE RECLINING POWER SEAT SWITCH KNOB
3.REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
4.REMOVE FRONT SEAT CUSHION SHIELD LH WITH FRONT INNER NO. 1 SEAT CUSHION SHIELD LH
5.REMOVE FRONT POWER SEAT SWITCH LH
6.REMOVE FRONT SEAT INNER CUSHION SHIELD LH
7.REMOVE FRONT SEAT INNER BELT ASSEMBLY LH
8.REMOVE FRONT SEAT CUSHION COVER WITH PAD
9.REMOVE POWER SEAT MOTOR ASSEMBLY (for Slide)
Detach the 2 wire harness clamps.
Detach the 4 clamps indicated by the arrows in the illustration and remove the seat cushion spring.
Remove the 4 bolts and seat cushion frame.
Put matchmarks on the seat track rail and sliding unit of the seat frame.
Disconnect the connector.
| *a | Component without harness connected
(Power Seat Motor Assembly) |
Connect the positive (+) battery terminal to terminal 1 of the power seat motor and the negative (-) battery terminal to terminal 2 and slide the seat to the foremost position.
Detach the claw and disconnect the connector from the seat frame.
Loosen the 2 nuts.
| *a | Component without harness connected
(Power Seat Motor Assembly) |
Connect the positive (+) battery terminal to terminal 2 of the power seat motor and the negative (-) battery terminal to terminal 1 and slide the seat to the rearmost position.
Using a 5 mm socket hexagon wrench, remove the 2 bolts.
Using a 4 mm socket hexagon wrench, remove the 4 bolts.
Remove the 2 nuts and power seat motor assembly (for Slide) together with the slide cable.
Do not apply excessive force to the slide cable (do not bend the slide cable 60° or more).
Remove the slide cable.