Wear protective gloves. Sharp areas on the parts may injure your hands.
A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
1.INSTALL POWER SEAT MOTOR ASSEMBLY (for Rear Lifter)
| *1 | Adjust Screw |
Using a 4 mm socket hexagon wrench, install the power seat motor assembly (for Rear Lifter) with the 2 bolts.
Clean the threads of the "TORX" bolt for the adjust screw with non-residue solvent (when reusing the "TORX" bolt).
Apply adhesive to the threads of the "TORX" bolt for the adjust screw (when reusing the "TORX" bolt).
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
Using a T40 "TORX" socket wrench, install the "TORX" bolt.
Connect the connector.
Using a T40 "TORX" socket wrench, install the tilt rod with the 2 "TORX" bolts for the tilt rod.
Install the nut.
Install the seat cushion frame with the 4 bolts.
Attach the 4 clamps indicated by the arrows in the illustration to install the seat cushion spring.
Attach the 2 wire harness clamps.
2.INSTALL FRONT SEAT CUSHION COVER WITH PAD
3.INSTALL FRONT SEAT INNER BELT ASSEMBLY LH
4.INSTALL FRONT SEAT INNER CUSHION SHIELD LH
5.INSTALL FRONT POWER SEAT SWITCH LH
6.INSTALL FRONT SEAT CUSHION SHIELD LH WITH FRONT INNER NO. 1 SEAT CUSHION SHIELD LH
7.INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
8.INSTALL RECLINING POWER SEAT SWITCH KNOB
9.INSTALL FRONT SEAT ASSEMBLY
10.INSPECT FRONT SEAT ASSEMBLY