Wear protective gloves. Sharp areas on the parts may injure your hands.
1.REMOVE FRONT SEAT ASSEMBLY
2.REMOVE RECLINING POWER SEAT SWITCH KNOB
3.REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
4.REMOVE FRONT SEAT CUSHION SHIELD LH WITH FRONT INNER NO. 1 SEAT CUSHION SHIELD LH
5.REMOVE FRONT POWER SEAT SWITCH LH
6.REMOVE FRONT SEAT INNER CUSHION SHIELD LH
7.REMOVE FRONT SEAT INNER BELT ASSEMBLY LH
8.REMOVE FRONT SEAT CUSHION COVER WITH PAD
9.REMOVE POWER SEAT MOTOR ASSEMBLY (for Rear Lifter)
Detach the 2 wire harness clamps.
Detach the 4 clamps indicated by the arrows in the illustration and remove the seat cushion spring.
Remove the 4 bolts and seat cushion frame.
Using a T40 "TORX" socket wrench, remove the 2 "TORX" bolts for the tilt rod.
Remove the nut and tilt rod.
| *1 | Adjust Screw |
Disconnect the connector.
Using a T40 "TORX" socket wrench, remove the "TORX" bolt for the adjust screw.
Using a 4 mm socket hexagon wrench, remove the 2 bolts and power seat motor assembly (for Rear Lifter).
When the adjust screw is locked in the uppermost or lowermost position, turn the screw to release the lock before removing the power seat motor assembly.