Home › Vehicle Interior › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY(for Manual Seat) › 2012.10–2013.10
RM1840EF _58 Vehicle Interior _009647 SEAT BELT _0052732 FRONT SEAT INNER BELT ASSEMBLY(for Manual Seat) A

SEAT BELT  FRONT SEAT INNER BELT ASSEMBLY(for Manual Seat)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FRONT SEAT CUSHION COVER LH

B342476

a.

Install the front seat cushion cover LH.

HINT:

Use the same procedure to install the front seat cushion cover on the other side.



Hide 2.INSTALL FRONT SEAT INNER BELT ASSEMBLY RH

a.

w/ Front Passenger Seat Belt Warning System:

i.
B278433
2.844,1.219 2.844,1.823 true 2.771,1.844 2.958,2.021 0.188,0.177 10 false *1
*1 Protruding Part


Install the front seat inner belt assembly LH with the nut.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)

NOTICE:

Do not allow the anchor part of the seat belt to overlap the protruding part of the seat adjuster.



ii.

Attach the wire harness to the clamp.


iii.
B284014
2.948,0.865 3.188,1.104 0.24,0.24 10 false *a
*a Front


Attach the 2 clamps as shown in the illustration.


iv.
B276730
1.759,2.386 1.971,2.547 0.212,0.161 10 *1 1.725,2.484 1.628,2.484 false 1.628,2.484 1.453,3.187 false
*1 Hog Ring Pliers


Using hog ring pliers, attach the cover to front cushion frame subassembly with new hog rings.



b.
B284018
2.885,1.219 2.885,1.688 true 2.823,1.75 3.083,2.01 0.26,0.26 10 false *1
*1 Protruding Part


w/o Front Passenger Seat Belt Warning System:

i.

Install the inner belt with the nut.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)

NOTICE:

Do not allow the anchor part of the seat belt to overlap the protruding part of the seat adjuster.




Hide 3.INSTALL FRONT SEAT INNER BELT ASSEMBLY LH

a.
B278434
0.594,1.698 0.594,1.229 true 0.531,1.74 0.844,1.896 0.313,0.156 10 false *1
*1 Protruding Part


Install the front seat inner belt assembly RH with the nut.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)

NOTICE:

Do not allow the anchor part of the seat belt to overlap the protruding part of the seat adjuster.



b.

Attach the wire harness to the clamp.


c.

Attach the clamp.