Home › Vehicle Interior › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY(for Extra Cab) › 2012.10–2013.10
RM1840EF _58 Vehicle Interior _009647 SEAT BELT _0052737 FRONT SEAT OUTER BELT ASSEMBLY(for Extra Cab) A

SEAT BELT  FRONT SEAT OUTER BELT ASSEMBLY(for Extra Cab)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 4.REMOVE REAR SEAT CUSHION ASSEMBLY LH (w/ Seat Cushion)

Hide 5.REMOVE REAR SEAT CUSHION ASSEMBLY RH (w/ Seat Cushion)

Hide 11.REMOVE QUARTER INSIDE TRIM BOARD LH

a.
B276966

Remove the bolt and disconnect the front seat outer belt floor anchor.


b.
B114992

w/ Seat cushion:

Remove the bolt and disconnect the rear No. 1 seat outer belt floor anchor.


c.
B276968

Detach the 4 claws, 3 guides and 7 clips and remove the quarter inside trim board LH.


Hide 12.REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH

a.
B342505
1.073,1.552 1.333,1.552 1.333,1.552 1.979,1.219 true 0.875,1.479 1.188,1.677 0.313,0.198 10 false *1
*1 Protective Tape


Remove the shoulder anchor.

i.

Using a screwdriver, detach the 4 claws and remove the seat belt anchor cover cap.

HINT:

Tape the screwdriver tip before use.



ii.

Remove the bolt and front seat outer belt shoulder anchor.



b.
B282312

w/o Pretensioner:

Remove the bolt and front seat outer belt assembly LH.


c.
B342488

w/ Pretensioner:

i.

Disconnect the pretensioner connector as shown in the illustration.


ii.
B321968

Remove the 2 bolts and front seat outer belt assembly LH.



Hide 14.REMOVE SHOULDER BELT ANCHORAGE PLATE COVER

B342506
1.76,0.281 2.073,0.479 0.313,0.198 10 false *a
*a Slide


a.

Remove the shoulder belt anchorage plate cover.


Hide 15.REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

B282303
1.337,0.985 1.509,1.188 0.172,0.203 10 *a
*a Rotate 90°


a.

Remove the bolt.


b.

Rotate the adjuster approximately 90°, and then pull and remove the front shoulder belt anchor adjuster assembly.