Home › Vehicle Interior › SEAT BELT › REAR SEAT OUTER BELT ASSEMBLY(for Extra Cab) › from 2012.10
RM1840EF _58 Vehicle Interior _009647 SEAT BELT _0052739 REAR SEAT OUTER BELT ASSEMBLY(for Extra Cab) A

SEAT BELT  REAR SEAT OUTER BELT ASSEMBLY(for Extra Cab)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



PROCEDURE

Hide 1.REMOVE REAR SEAT CUSHION ASSEMBLY LH (w/ Seat Cushion)

Hide 2.REMOVE REAR SEAT CUSHION ASSEMBLY RH (w/ Seat Cushion)

Hide 8.REMOVE QUARTER INSIDE TRIM BOARD LH

B276966

a.

Remove the bolt and disconnect the front seat outer belt floor anchor.


b.
B114992

Remove the bolt and disconnect the rear No. 1 seat outer belt floor anchor.


c.
B276968

Detach the 4 claws, 3 guides and 7 clips and remove the quarter inside trim board.


Hide 9.REMOVE REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH

a.
B282388

Using a screwdriver, detach the 2 claws and open the seat belt anchor cover.

HINT:

Tape the screwdriver tip before use.



b.

Remove the bolt.


c.
B342524

Remove the bolt and rear No. 1 seat outer belt assembly LH.