Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR(for 1KD-FTV, 2KD-FTV) › 2011.10–2012.01
RM1840EF _58 Vehicle Interior _009648 HEATING / AIR CONDITIONING _0052748 COMPRESSOR(for 1KD-FTV, 2KD-FTV) A

HEATING / AIR CONDITIONING  COMPRESSOR(for 1KD-FTV, 2KD-FTV)  INSTALLATION  


PROCEDURE

Hide 1.ADJUST COMPRESSOR OIL

a.

When replacing the compressor and magnet clutch with a new one, gradually discharge the refrigerant gas from the service valve, and drain the following amount of oil from the new compressor and magnet clutch before installation.

Standard:

(Oil capacity inside the new compressor and magnet clutch: 80 + 15 cc (2.71 + 0.51 fl.oz)) - (Remaining oil amount in the removed compressor and magnet clutch) = (Oil amount to be removed from the new compressor)


NOTICE:
·

When checking the compressor oil level, follow the A/C system precautions.

·

If a new compressor and magnet clutch is installed without removing the oil remaining in the pipes of the vehicle, the oil amount will be too large. This prevents heat exchange in the refrigerant cycle and causes refrigerant failure.

·

If the volume of oil remaining in the removed compressor and magnet clutch is small, check for oil leakage.

·

Be sure to use ND-OIL 8 or equivalent compressor oil.




Hide 2.INSTALL COOLER COMPRESSOR ASSEMBLY

E225067
0.648,1.188 0.762,1.362 0.115,0.175 10 1 0.321,1.847 0.436,2.021 0.115,0.175 10 2 0.814,1.858 0.928,2.033 0.115,0.175 10 3 0.092,1.188 0.206,1.362 0.115,0.175 10 4

a.

Install the cooler compressor assembly with the 4 bolts and tighten the bolts in the order shown in the illustration.

Torque:
25 N*m (250 kgf*cm, 18 ft.*lbf)


b.

Connect the connector.


Hide 3.INSTALL NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

a.

Remove the vinyl tape attached to the No. 1 cooler refrigerant discharge hose.


b.

Sufficiently apply compressor oil to a new O-ring and the fitting surface of the compressor.

Compressor oil:

ND-OIL 8 or equivalent



c.

Install the O-ring to the No. 1 cooler refrigerant discharge hose.


d.

Connect the No. 1 cooler refrigerant discharge hose with the bolt.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


Hide 4.INSTALL SUCTION HOSE SUB-ASSEMBLY

a.

Remove the vinyl tape attached to the suction hose sub-assembly.


b.

Sufficiently apply compressor oil to a new O-ring and the fitting surface of the compressor.

Compressor oil:

ND-OIL 8 or equivalent



c.

Install the O-ring to the suction hose sub-assembly.


d.

Connect the suction hose sub-assembly with the bolt.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)