1.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
2.REMOVE RADIATOR GRILLE
3.REMOVE FRONT BUMPER COVER
4.REMOVE ENGINE SIDE COVER SUB-ASSEMBLY LH (for 4WD and Pre-Runner)
5.REMOVE ENGINE SIDE COVER SUB-ASSEMBLY RH (for 4WD and Pre-Runner)
6.REMOVE NO. 1 ENGINE UNDER COVER (except 4WD and Pre-Runner)
7.REMOVE FRONT BUMPER REINFORCEMENT EXTENSION LH (for 4WD and Pre-Runner)
8.REMOVE FRONT BUMPER REINFORCEMENT EXTENSION RH (for 4WD and Pre-Runner)
9.REMOVE FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY
10.REMOVE RADIATOR SIDE DEFLECTOR RH
Remove the 3 clips and radiator side deflector RH.
11.REMOVE V-BANK COVER (for 1GR-FE)
12.REMOVE AIR CLEANER ASSEMBLY (for 1GR-FE)
13.REMOVE NO. 2 AIR CLEANER HOSE (for 1GR-FE)
14.REMOVE AIR CLEANER ASSEMBLY (for 1KD-FTV, 2KD-FTV)
15.REMOVE INTAKE AIR CONNECTOR AND AIR CLEANER ASSEMBLY (for TR Series Engine)
16.REMOVE AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY
Disconnect the connector.
Remove the 3 bolts and air conditioning tube and accessory assembly (air conditioning pressure sensor).
Remove the O-rings from the air conditioning tube and accessory assembly (air conditioning pressure sensor).
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.