Home › Vehicle Interior › HEATING / AIR CONDITIONING › RELAY(for Heater) › from 2012.10
RM1840EF _58 Vehicle Interior _009648 HEATING / AIR CONDITIONING _0052760 RELAY(for Heater) A

HEATING / AIR CONDITIONING  RELAY(for Heater)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION (w/ Airbag System)

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Airbag System)

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 4.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 5.REMOVE NO. 1 HEATER RELAY

E226124

a.

Remove the 2 nuts.


b.

Detach the clamp and disconnect the driver side junction block.


c.
E226175

Remove the No. 1 heater relay.