Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR(for 1GR-FE) › from 2012.04
RM1840EF _58 Vehicle Interior _009648 HEATING / AIR CONDITIONING _0052766 COMPRESSOR(for 1GR-FE) A

HEATING / AIR CONDITIONING  COMPRESSOR(for 1GR-FE)  INSTALLATION  


PROCEDURE

Hide 1.ADJUST COMPRESSOR OIL

a.

When replacing the compressor and magnet clutch with a new one, gradually discharge the refrigerant gas from the service valve, and drain the following amount of oil from the new compressor and magnet clutch before installation.

Standard:

(Oil capacity inside the new compressor and magnet clutch: 180 + 15 cc (6.08 + 0.51 fl.oz.)) - (Remaining oil amount in the removed compressor and magnet clutch) = (Oil amount to be removed from the new compressor)


NOTICE:
·

When checking the compressor oil level, follow the A/C system precautions.

·

If a new compressor and magnet clutch is installed without removing the oil remaining in the pipes of the vehicle, the oil amount will be too large. This prevents heat exchange in the refrigerant cycle and causes refrigerant failure.

·

If the volume of oil remaining in the removed compressor and magnet clutch is small, check for oil leakage.

·

Be sure to use ND-OIL 8 or equivalent compressor oil.




Hide 2.INSTALL COOLER COMPRESSOR ASSEMBLY

a.
E174571

Install the compressor with the 4 bolts and tighten the bolts in the order shown in the illustration.

Torque:
25 N*m (250 kgf*cm, 18 ft.*lbf)


b.
E174570

Connect the connector.


Hide 3.INSTALL NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

a.
E174569

Remove the vinyl tape attached to the hose.


b.

Sufficiently apply compressor oil to a new O-ring and the fitting surface of the compressor.

Compressor oil:

ND-OIL 8 or equivalent



c.

Install the O-ring to the discharge hose.


d.

Connect the discharge hose with the bolt.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


Hide 4.INSTALL SUCTION HOSE SUB-ASSEMBLY

a.
E174568

Remove the vinyl tape attached to the hose.


b.

Sufficiently apply compressor oil to a new O-ring and the fitting surface of the compressor.

Compressor oil:

ND-OIL 8 or equivalent



c.

Install the O-ring to the suction hose.


d.

Connect the suction hose with the bolt.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)