A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
1.INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY
Attach the 5 guides and 8 claws to install the upper instrument panel.
Install the 2 bolts <A> and 2 screws <B>.
| *A | w/o Front Passenger Airbag | *B | w/ Front Passenger Airbag |
| *1 | Bolt <A> | *2 | Screw <B> |
2.INSTALL FRONT PILLAR GARNISH LH
Attach the 2 guides and 2 clips to install the front pillar garnish.
Install the front door opening trim.
3.INSTALL FRONT PILLAR GARNISH RH
Use the same procedure described for the LH side.
4.INSTALL FRONT ASSIST GRIP SUB-ASSEMBLY (w/ Assist Grip)
5.INSTALL ASSIST GRIP PLUG LH (w/ Assist Grip)
6.INSTALL ASSIST GRIP PLUG RH (w/ Assist Grip)
7.INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY (w/ Front Passenger Airbag)
8.INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY (w/ Front Passenger Airbag)
| *1 | Hinge |
Attach the 2 hinges to install the glove compartment door.
| *1 | Stopper |
While pushing in the sides of the glove compartment door as indicated by the arrows in the illustration, close the door to engage it to the 2 stoppers.
9.INSTALL RADIO TUNER OPENING COVER (w/o Audio)
Install the radio tuner opening cover with the 4 screws.
10.INSTALL NAVIGATION RECEIVER ASSEMBLY (w/ Navigation System)
11.INSTALL RADIO RECEIVER ASSEMBLY (w/ Audio)
for Radio Receiver Type:
(See page Audio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER>INSTALLATION)
for Radio and Display Type:
(See page Audio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER>INSTALLATION)
12.INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
for Manual Air Conditioning System:
Connect the connectors.
Attach the 4 claws to connect the air conditioner control.
Attach the 10 claws and 4 clips to install the center instrument cluster finish panel.
for Automatic Air Conditioning System:
Connect the connectors.
Attach the 8 claws and 4 clips to install the center instrument cluster finish panel.
13.INSTALL COMBINATION METER ASSEMBLY
14.INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL
Attach the 3 guides and 2 claws to install the No. 1 instrument cluster finish panel.
Install the clip <C>.
15.INSTALL STEERING WHEEL ASSEMBLY
16.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Airbag System)
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
17.CHECK SRS WARNING LIGHT (w/ Airbag System)