Home › Vehicle Interior › INTERIOR PANELS / TRIM › ROOF HEADLINING(for Double Cab) › from 2012.10
RM1840EF _58 Vehicle Interior _009650 INTERIOR PANELS / TRIM _0052776 ROOF HEADLINING(for Double Cab) A

INTERIOR PANELS / TRIM  ROOF HEADLINING(for Double Cab)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION (w/ Airbag System)

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Airbag System)

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 4.REMOVE FRONT DOOR SCUFF PLATE LH

B276926
1.688,1.958 2.052,1.781 true 1.51,1.927 1.698,2.083 0.188,0.156 10 false *1
*1 Protective Tape


a.

Put protective tape around the front door scuff plate.


b.

Using a moulding remover, detach the 7 claws and 3 clips, and remove the front door scuff plate.


Hide 5.REMOVE FRONT DOOR SCUFF PLATE RH

HINT:

Use the same procedure described for the LH side.


Hide 6.REMOVE FRONT DOOR OPENING TRIM LH

B276985

a.

Remove the front door opening trim.


Hide 7.REMOVE FRONT DOOR OPENING TRIM RH

HINT:

Use the same procedure described for the LH side.


Hide 8.REMOVE ASSIST GRIP PLUG LH

B277720
1.271,1.063 1.99,1.063 true 2.021,0.969 2.25,1.229 0.229,0.26 10 false *1
*1 Protective Tape


HINT:

Use the same procedure for both front No. 1 assist grip plugs.


a.

Using a screwdriver, detach the 2 claws and remove the front No. 1 assist grip plug.

HINT:

Tape the screwdriver tip before use.



Hide 9.REMOVE ASSIST GRIP PLUG RH

HINT:

Use the same procedure described for the LH side.


Hide 10.REMOVE FRONT ASSIST GRIP SUB-ASSEMBLY

B206335

HINT:

Use the same procedure for both assist grips.


a.

Remove the 2 screws and front assist grip.


Hide 11.REMOVE FRONT PILLAR GARNISH LH

B276932

a.

Detach the 2 clips and 2 guides and remove the front pillar garnish.


Hide 12.REMOVE FRONT PILLAR GARNISH RH

HINT:

Use the same procedure described for the LH side.


Hide 13.REMOVE REAR DOOR SCUFF PLATE LH

B277892
1.167,1.323 0.927,1.865 true 0.813,1.927 1.01,2.094 0.198,0.167 10 false *1
*1 Protective Tape


a.

Put protective tape around the rear door scuff plate.


b.

Using a moulding remover, detach the 7 claws and 2 clips, and remove the rear door scuff plate.


Hide 14.REMOVE REAR DOOR SCUFF PLATE RH

HINT:

Use the same procedure described for the LH side.


Hide 15.REMOVE REAR DOOR OPENING TRIM LH

B276987

a.

Remove the rear door opening trim.


Hide 16.REMOVE REAR DOOR OPENING TRIM RH

HINT:

Use the same procedure described for the LH side.


Hide 17.REMOVE LOWER CENTER PILLAR GARNISH LH

B276978

a.

Remove the bolt and disconnect the front seat outer belt floor anchor.


b.
B276929

Detach the 2 claws, 2 guides and 2 clips and remove the lower center pillar garnish.


Hide 18.REMOVE LOWER CENTER PILLAR GARNISH RH

HINT:

Use the same procedure described for the LH side.


Hide 19.REMOVE CENTER PILLAR GARNISH LH

B276930
2.115,1.208 2.771,0.927 true 2.802,0.792 3.01,1.052 0.208,0.26 10 false *1
*1 Protective Tape


a.

Using a screwdriver, detach the 4 claws and remove the front seat belt shoulder anchor cover.

HINT:

Tape the screwdriver tip before use.



b.

Remove the bolt and disconnect the front seat belt shoulder anchor.


c.
B276931

Detach the clip.


d.

Pull the center pillar garnish in the direction indicated by the arrow in the illustration to detach the guide and remove the center pillar garnish.


Hide 20.REMOVE CENTER PILLAR GARNISH RH

HINT:

Use the same procedure described for the LH side.


Hide 21.REMOVE UPPER BACK PANEL GARNISH

B276979

a.

Detach the 4 claws and 5 clips and remove the upper back panel garnish.


Hide 22.REMOVE LOWER QUARTER TRIM PANEL LH

B276982

a.

Detach the claw and 3 clips and remove the lower quarter trim panel.


Hide 23.REMOVE LOWER QUARTER TRIM PANEL RH

HINT:

Use the same procedure described for the LH side.


Hide 24.REMOVE QUARTER INSIDE TRIM BOARD LH

B276936
1.406,1.094 1.125,0.656 false 0.938,0.51 1.125,0.688 0.188,0.177 10 false *1
*1 Protective Tape


a.

Using a screwdriver, detach the 2 claws and open the rear seat belt shoulder anchor cover.

HINT:

Tape the screwdriver tip before use.



b.

Remove the bolt and disconnect the rear seat belt shoulder anchor.


c.
B276981

Detach the 4 clips and remove the quarter inside trim board.


Hide 25.REMOVE QUARTER INSIDE TRIM BOARD RH

HINT:

Use the same procedure described for the LH side.


Hide 27.REMOVE NO. 1 ROOM LIGHT ASSEMBLY

Hide 28.REMOVE VISOR ASSEMBLY LH

B266814

a.

Detach the guide.


b.

Remove the 2 screws and visor.


Hide 29.REMOVE VISOR ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 30.REMOVE VISOR HOLDER LH

B266815

a.

Remove the screw.


b.

Detach the 2 claws and remove the visor holder.


Hide 31.REMOVE VISOR HOLDER RH

HINT:

Use the same procedure described for the LH side.


Hide 32.REMOVE ASSIST GRIP

B277629
1.177,1.031 1.594,1.198 true 1.635,1.156 1.854,1.354 0.219,0.198 10 false *1
*1 Protective Tape


HINT:

Use the same procedure for all assist grips.


a.

Using a screwdriver, detach the 4 claws and open the 2 covers.

HINT:

Tape the screwdriver tip before use.



b.
B206336

Remove the 2 screws and assist grip.


Hide 33.REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 34.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

Hide 40.REMOVE ROOF HEADLINING ASSEMBLY

B283170

a.

Detach the 5 clamps from the front pillar.


b.
B206359

Disconnect the connectors and detach the 4 clamps.


c.
B257918

Using a clip remover, remove the 5 clips.


d.
B276991

Remove the roof headlining as shown in the illustration.

NOTICE:

Be careful not to damage the roof headlining when removing it.



Hide 41.REMOVE FRONT SIDE RAIL SPACER LH

B276948

a.

Detach the 2 claws and remove the front side rail spacer.


Hide 42.REMOVE FRONT SIDE RAIL SPACER RH

HINT:

Use the same procedure described for the LH side.


Hide 43.REMOVE SIDE RAIL SPACER

B278255

a.

Detach the 2 claws and remove the side rail spacer.


Hide 44.REMOVE REAR NO. 2 SIDE RAIL SPACER LH

B276949

HINT:

Use the same procedure for both rear No. 2 side rail spacers.


a.

Detach the 2 claws and remove the rear No. 2 side rail spacer.


Hide 45.REMOVE REAR NO. 2 SIDE RAIL SPACER RH

HINT:

Use the same procedure described for the LH side.


Hide 46.REMOVE REAR NO. 3 SIDE RAIL SPACER LH

B276980

a.

Detach the 3 claws and remove the rear No. 3 side rail spacer.


Hide 47.REMOVE REAR NO. 3 SIDE RAIL SPACER RH

HINT:

Use the same procedure described for the LH side.