Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR(for Rear Door) › 2012.04–2012.10
RM1840EF _59 Vehicle Exterior _009651 WINDOW / GLASS _0052786 POWER WINDOW REGULATOR MOTOR(for Rear Door) A

WINDOW / GLASS  POWER WINDOW REGULATOR MOTOR(for Rear Door)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

a.

Apply MP grease to the sliding and rotating areas of the regulator motor assembly LH.


b.

Using a T25 "TORX" socket wrench, install the power window regulator motor with the 3 screws.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


Hide 2.INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

Hide 3.INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH

Hide 4.INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

Hide 5.INSTALL REAR DOOR GLASS RUN LH

Hide 6.INSTALL REAR DOOR SERVICE HOLE COVER LH

Hide 7.INSTALL REAR DOOR NO. 2 TRIM BRACKET

Hide 8.INSTALL REAR DOOR INSIDE HANDLE SUB-ASSEMBLY LH

Hide 9.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 11.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL LH

Hide 12.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).