Use the same procedure for the RH and LH sides.
The procedure listed below is for the RH side.
1.REMOVE FRONT SEAT ASSEMBLY RH
for Bench Seat Type:
(See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Bench Seat Type)>REMOVAL)
for Separate Seat Type:
(See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Separate Seat Type)>REMOVAL)
2.REMOVE FRONT DOOR SCUFF PLATE RH
| *1 | Protective Tape |
Put protective tape around the front door scuff plate.
Using a moulding remover D, detach the 4 clips and 8 claws and remove the front door scuff plate.
3.REMOVE FRONT DOOR OPENING TRIM RH
Partially remove the front door opening trim RH so that the quarter inside trim board RH, quarter pillar garnish RH and inner upper roof side garnish RH can be removed (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Extra Cab)>REMOVAL).
4.REMOVE REAR SEAT ASSEMBLY
5.REMOVE LOWER BACK PANEL GARNISH
6.REMOVE QUARTER INSIDE TRIM BOARD RH
Remove the bolt and disconnect the front seat outer belt floor anchor.
Detach the 4 claws, 3 guides and 7 clips and remove the quarter inside trim board RH.
7.REMOVE QUARTER PILLAR GARNISH RH
| *1 | Protective Tape |
Using a screwdriver, detach the 4 claws and remove the front seat belt anchor cover cap.
Tape the screwdriver tip before use.
Remove the bolt and disconnect the front seat belt shoulder anchor.
Detach the 2 clips and remove the quarter pillar garnish.
8.REMOVE INNER UPPER ROOF SIDE GARNISH RH
Detach the 3 clips and remove the inner upper roof side garnish RH.
9.REMOVE QUARTER WINDOW GLASS RH
When separating the glass from the vehicle, be careful not to damage the vehicle's paint or interior/exterior ornaments.
Procedures must be performed with 2 people, where the second person supports the glass.
Release the quarter window lock assembly RH.
Remove the 2 bolts.
Remove the 2 bolts.
Remove the quarter window glass RH as shown in the illustration.
10.REMOVE QUARTER WINDOW LOCK ASSEMBLY RH
| *1 | Retainer |
| *2 | Bush |
| *3 | Screw |
Remove the screw, bush, quarter window hinge retainer RH and quarter window lock assembly RH.
11.REMOVE QUARTER WINDOW HINGE RH
| *1 | Retainer |
| *2 | Bush |
| *3 | Washer |
| *4 | Screw |
Remove the 2 screws, 2 washers, 2 retainers, 2 bushes and 2 quarter window hinges RH.
12.REMOVE QUARTER WINDOW WEATHERSTRIP RH
Remove the quarter window weatherstrip RH.