Home › Vehicle Exterior › WIPER / WASHER › WIPER SWITCH › from 2012.04
RM1840EF _59 Vehicle Exterior _009654 WIPER / WASHER _0052811 WIPER SWITCH A

WIPER / WASHER  WIPER SWITCH  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE STEERING COLUMN LOWER COVER

Hide 4.REMOVE STEERING COLUMN UPPER COVER

Hide 5.REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY

E225945

a.

Disconnect the connectors.


b.

Detach the claw and remove the windshield wiper switch.

NOTICE:

Do not push the claw with excessive force as damage may occur.