Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY › 2012.04–2012.10
RM1840EF _55 Steering _009629 STEERING COLUMN _0052643 STEERING COLUMN ASSEMBLY A

STEERING COLUMN  STEERING COLUMN ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

w/ Airbag System:

Some of these service operations affect the SRS. Read the precautionary notices concerning the SRS before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


PROCEDURE

Hide 1.PLACE FRONT WHEELS FACING STRAIGHT AHEAD

Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

w/ Airbag System:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE STEERING WHEEL ASSEMBLY

Hide 4.REMOVE STEERING COLUMN LOWER COVER

a.
C238860

Remove the 3 bolts and lower cover.


Hide 5.REMOVE STEERING COLUMN UPPER COVER

a.

Detach the claw and remove the upper cover.


Hide 6.REMOVE COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY (w/ Airbag System)

a.

Disconnect the connectors from the combination switch assembly with spiral cable sub-assembly.


b.
C281740
2.656,0.333 2.813,0.198 2.813,0.198 2.948,0.198 true 2.708,0.542 2.781,0.667 2.781,0.667 2.927,0.667 true 2.979,0.104 3.292,0.26 0.313,0.156 10 false *1 2.958,0.573 3.271,0.729 0.313,0.156 10 false *2
*1 Clamp
*2 Claw


Use pliers to hold the clamp and raise the claw with a screwdriver. Remove the combination switch assembly with spiral cable sub-assembly from the steering column assembly.


Hide 7.REMOVE COMBINATION SWITCH ASSEMBLY (w/o Airbag System)

HINT:

Refer to the step "REMOVE COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY".


a.
C281785
0.917,1.26 0.76,0.917 0.76,0.917 0.604,0.917 false 0.417,0.823 0.729,1.021 0.313,0.198 10 false *1
*1 Protective Tape


Using a screwdriver, detach the 3 claws the horn contact plate.

HINT:

Tape the screwdriver tip before use.



Hide 8.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

Hide 9.DISCONNECT STEERING SLIDING YOKE

Hide 10.REMOVE STEERING COLUMN HOLE COVER SUB-ASSEMBLY

a.
C214218

Remove the 3 bolts and cover.


Hide 11.REMOVE STEERING COLUMN ASSEMBLY

a.

Disconnect the connectors and detach the wire harness clamps from the steering column.


b.
C214219

Remove the 3 bolts and pull out the steering column together with the steering sliding with coupling yoke.