Home › Engine / Hybrid System › 2TR-FBE ENGINE CONTROL › SFI SYSTEM › from 2012.10
RM1840EF _51 Engine / Hybrid System _009571 2TR-FBE ENGINE CONTROL _0052126 SFI SYSTEM C

2TR-FBE ENGINE CONTROL  SFI SYSTEM  P0505  Idle Control System Malfunction  


DESCRIPTION

The idling speed is controlled by the electronic throttle control system. The electronic throttle control system is comprised of: 1) a one-valve-type throttle body; 2) the throttle actuator, which operates the throttle valve; 3) the throttle position sensor, which detects the opening angle of the throttle valve; 4) the accelerator pedal position sensor, which detects the accelerator pedal position; and 5) the ECM, which controls the electronic throttle control system. Based on the target idling speed, the ECM controls the throttle actuator to provide the proper throttle valve opening angle.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P0505 Idle Control System Malfunction The idle speed continues to vary greatly from the target speed (2 trip detection logic).
·

Electronic throttle control system

·

Air induction system

·

PCV hose connection

·

ECM


Comes on DTC stored

CAUTION / NOTICE / HINT

HINT:
·

The following condition may also cause DTC P0505 to be stored:

1.

The throttle valve is not fully closed (e.g. the accelerator pedal is slightly depressed by something such as the floor carpet overlapping the accelerator pedal).


·

Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.



PROCEDURE

1.CHECK FOR ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0505)
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON and turn the tester on.


c.

Enter the following menus: Powertrain / Engine and ECT / DTC.

Powertrain > Engine and ECT > Trouble Codes
50001 234

d.

Read the DTCs.

Result:
Result Proceed to
DTC P0505 is output A
DTC P0505 and other DTCs are output B


HINT:

If any DTCs other than P0505 are output, troubleshoot those DTCs first.




A

2.CHECK PCV HOSE CONNECTIONS

B

2.CHECK PCV HOSE CONNECTIONS
a.

Check the PCV hose connection.

OK:

PCV hose is connected correctly and is not damaged.



Result:
Proceed to
OK
NG



OK

3.CHECK AIR INDUCTION SYSTEM

NG

REPAIR OR REPLACE PCV HOSE

3.CHECK AIR INDUCTION SYSTEM
a.

Check the air induction system for vacuum leakage.

Click hereEngine / Hybrid System>2TR-FBE INTAKE / EXHAUST>INTAKE SYSTEM>ON-VEHICLE INSPECTION

OK:

No leakage from air induction system.



Result:
Proceed to
OK
NG



OK

4.CHECK THROTTLE VALVE

NG

REPAIR OR REPLACE AIR INDUCTION SYSTEM

4.CHECK THROTTLE VALVE
a.

Check for contamination between the throttle valve and housing, and check that the throttle valve moves smoothly.

OK:

Throttle valve is not contaminated with foreign objects and moves smoothly.



Result:
Proceed to
OK
NG



OK

NG

REPLACE THROTTLE BODY WITH MOTOR ASSEMBLY