| Detection Item | Symptom | Trouble Area |
|---|---|---|
| ECM Communication Stop Mode | Either condition is met:
·
"ECM (Engine)" is not displayed on the "Bus Check" screen. ·
"ECM Communication Stop Mode" in "DTC Communication Table" applies. |
·
Power source or inside of ECM ·
ECM |
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Disconnect the C22, C23, G38 and G39 ECM connectors.
| *a | Front view of wire harness connector
(to ECM) |
- | - |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G38-2 (BATT) - Body ground | Always | 11 to 14 V |
| G39-1 (+B) - Body ground | Battery positive (+) voltage applied to terminal G39-8 (MREL) | 11 to 14 V |
| G39-9 (IGSW) - Body ground | Ignition switch ON | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C23-7 (E1) - Body ground | Always | Below 1 Ω |
| C22-7 (E01) - Body ground | Always | Below 1 Ω |
| C22-6 (E02) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG