Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM › 2012.01–2012.04
RM1840EF _58 Vehicle Interior _009645 SUPPLEMENTAL RESTRAINT SYSTEMS _0052709 AIRBAG SYSTEM C

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  B1000/31  Center Airbag Sensor Assembly Malfunction  


DESCRIPTION

The center airbag sensor consists of an airbag sensor, safing sensor, drive circuit, diagnosis circuit, ignition control circuit, etc.

If the center airbag sensor receives signals from the airbag sensor, it determines whether the SRS should be activated.

DTC B1000/31 is stored when a malfunction is detected in the center airbag sensor.

DTC No. Detection Item DTC Detection Condition Trouble Area Test Mode / Check Mode
B1000/31 Center Airbag Sensor Assembly Malfunction A center airbag sensor malfunction. Center airbag sensor assembly DTC is not output in check mode.

HINT:

When a trouble code is output simultaneously with B1000/31, repair the malfunction indicated by the other code first.


CAUTION / NOTICE / HINT

NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable from the negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



PROCEDURE

1.CHECK DTC
a.

Turn the ignition switch to ON, and wait for at least 60 seconds.


b.

Check for DTCs.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR

Body Electrical > SRS Airbag > Trouble Codes
50001 63
Result:
Result Proceed to
DTC B1000/31 is output A
DTC B1000/31 and other DTCs are output B


NOTICE:

If only DTC B1000/31 is output, do not clear the DTCs. Instead, immediately replace the center airbag sensor assembly.


HINT:

If any DTCs other than DTC B1000/31 are output, troubleshoot those DTCs first.




A

B