Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) › 2012.04–2012.10
RM1840EF _58 Vehicle Interior _009648 HEATING / AIR CONDITIONING _0052762 AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) C

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)  14  Engine Coolant Temperature Communication Circuit  


DESCRIPTION

The engine coolant temperature sensor connected to the ECM detects the engine coolant temperature, which is used for warm up control when the engine is cold. The engine coolant temperature sensor sends a signal to the air conditioning amplifier assembly via the ECM.

DTC No. Detection Item DTC Detection Condition Trouble Area Memory Note
14 Engine Coolant Temperature Communication Circuit An open or short in engine coolant temperature communication circuit
·

ECD system (for 1KD-FTV [w/ EGR Cooler])

·

ECD system (for 1KD-FTV [w/o EGR Cooler])

·

SFI system (for 2TR-FBE)

·

Air conditioning amplifier assembly

·

Harness or connector


Memorized
(8.5 min. or more)
-

WIRING DIAGRAM

E253379
3.141,0.635 3.555,0.785 0.413,0.150 10 G154 3.209,0.864 3.389,1.015 0.180,0.150 10 *5 3.225,0.435 3.420,0.586 0.195,0.150 10 14 2.749,0.635 3.097,0.785 0.348,0.150 10 C97 2.775,0.864 2.955,1.015 0.180,0.150 10 *4 2.791,0.435 2.986,0.586 0.195,0.150 10 26 2.273,0.635 2.686,0.785 0.413,0.150 10 G156 2.34,0.864 2.520,1.015 0.180,0.150 10 *3 2.357,0.435 2.551,0.586 0.195,0.150 10 16 1.838,0.635 2.252,0.785 0.413,0.150 10 G148 1.906,0.864 2.086,1.015 0.180,0.150 10 *2 1.922,0.435 2.117,0.586 0.195,0.150 10 16 1.588,0.435 1.788,0.586 0.199,0.150 10 2 1.543,0.864 1.723,1.015 0.180,0.150 10 *1 1.481,0.636 1.770,0.786 0.289,0.150 10 G39 5.476,1.096 5.816,1.246 0.340,0.150 10 G94 5.444,0.529 5.595,0.679 0.151,0.150 10 8 0.323,1.664 1.895,1.814 1.572,0.150 10 *2: for 1KD-FTV for DPF 0.323,1.402 2.839,1.552 2.517,0.150 10 *1: for 1KD-FTV except DPF and i-ART 0.323,2.448 1.460,2.599 1.137,0.150 10 *5: for 1GR-FE 0.323,2.187 1.460,2.337 1.137,0.150 10 *4: for 2TR-FBE 0.85,1.131 1.232,1.330 0.382,0.199 10 ECM 0.918,0.625 1.426,0.781 0.508,0.156 10 THWO 5.676,0.628 5.959,0.799 0.283,0.170 10 TW 5.476,1.251 7.101,1.662 1.625,0.411 10 Air Conditioning Amplifier Assembly 0.323,1.925 2.413,2.076 2.091,0.150 10 *3: for 1KD-FTV for i-ART

PROCEDURE

1.CHECK VEHICLE TYPE
a.

Check the vehicle type.


Result:
Result Proceed to
for 1KD-FTV A
for 2TR-FBE or 1GR-FE B



A

2.CHECK FOR DTC (ENGINE CONTROL SYSTEM)

B

4.CHECK FOR DTC (ENGINE CONTROL SYSTEM)
2.CHECK FOR DTC (ENGINE CONTROL SYSTEM)


Result:
Result Proceed to
DTC (P0115, P0117 or P0118) is not output. A
DTC (P0115, P0117 or P0118) is output. (for 1KD-FTV [w/ EGR Cooler]) B
DTC (P0115, P0117 or P0118) is output. (for 1KD-FTV [w/o EGR Cooler]) C
DTC (P0115, P0117 or P0118) is output. (for 1KD-FTV [for DPF]) D
DTC (P0115, P0117 or P0118) is output. (for 1KD-FTV [for i-ART]) E



A

3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - ECM)

B

C

D

E

3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - ECM)
a.

Disconnect the G94 air conditioning amplifier assembly connector.


b.

Disconnect the G39*1, G148*2 or G156*3 ECM connector.

*1: for 1KD-FTV except DPF and i-ART

*2: for 1KD-FTV for DPF

*3: for 1KD-FTV for i-ART



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
for 1KD-FTV except DPF and i-ART:
Tester Connection Condition Specified Condition
G94-8 (TW) - G39-2 (THWO) Always Below 1 Ω
G94-8 (TW) - Body ground Always 10 kΩ or higher

for 1KD-FTV for DPF:
Tester Connection Condition Specified Condition
G94-8 (TW) - G148-16 (THWO) Always Below 1 Ω
G94-8 (TW) - Body ground Always 10 kΩ or higher

for 1KD-FTV for i-ART:
Tester Connection Condition Specified Condition
G94-8 (TW) - G156-16 (THWO) Always Below 1 Ω
G94-8 (TW) - Body ground Always 10 kΩ or higher


Result:
Result Proceed to
OK (When troubleshooting according to problem symptoms table.) A
OK (When troubleshooting according to DTC.) B
NG C




A

B

C

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.CHECK FOR DTC (ENGINE CONTROL SYSTEM)


Result:
Result Proceed to
DTC (P0115, P0117 or P0118) is not output. A
DTC (P0115, P0117 or P0118) is output. (for 2TR-FBE) B
DTC (P0115, P0117 or P0118) is output. (for 1GR-FE) C



A

5.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - ECM)

B

C

5.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - ECM)
a.

Disconnect the G94 air conditioning amplifier assembly connector.


b.

Disconnect the C97*1 or G154*2 ECM connector.

*1: for 2TR-FBE

*2: for 1GR-FE



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
for 2TR-FBE:
Tester Connection Condition Specified Condition
G94-8 (TW) - C97-26 (THWO) Always Below 1 Ω
G94-8 (TW) - Body ground Always 10 kΩ or higher

for 1GR-FE:
Tester Connection Condition Specified Condition
G94-8 (TW) - G154-14 (THWO) Always Below 1 Ω
G94-8 (TW) - Body ground Always 10 kΩ or higher


Result:
Result Proceed to
OK (When troubleshooting according to problem symptoms table.) A
OK (When troubleshooting according to DTC.) B
NG C




A

B

C

REPAIR OR REPLACE HARNESS OR CONNECTOR