To detect atmospheric pressure, the built-in atmospheric pressure sensor in the ECM is used. Using the atmospheric pressure, the ECM corrects the injection volume, timing and duration, and adjusts the common rail internal fuel pressure in order to optimize engine combustion.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P2226 | Barometric Pressure Circuit | Atmospheric pressure sensor voltage is 1.4 V or less, or 4.0 V or higher for 0.5 seconds (1 trip detection logic). | ECM | Comes on | DTC stored |
| P2228 | Barometric Pressure Circuit Low Input | Atmospheric pressure sensor voltage is 1.4 V or less for 0.5 seconds (1 trip detection logic). | ECM | Comes on | DTC stored |
| P2229 | Barometric Pressure Circuit High Input | Atmospheric pressure sensor voltage is 4.0 V or higher for 0.5 seconds (1 trip detection logic). | ECM | Comes on | DTC stored |
| DTC No. | Data List |
|---|---|
| P2226 | ·
Atmosphere Pressure ·
MAP |
| P2228 | |
| P2229 |
When the ignition switch is ON, the intake manifold pressure, "MAP", is approximately equal to atmospheric pressure.
Under standard atmospheric pressure conditions, the output of the atmospheric pressure sensor is 101 kPa. For every 100 m increase in elevation, pressure drops by 1 kPa. This varies by weather (high atmospheric pressure, low atmospheric pressure).
If DTC P2226, P2228 and/or P2229 is stored, the following symptoms may appear:
Misfire
Combustion noise
Black smoke
White smoke
| DTC Detection Drive Pattern | Ignition switch ON for 1 second |
Inspect the fuses of circuits related to this system before performing the following inspection procedure.
After replacing the ECM, the new ECM needs registration (See page Engine / Hybrid System>1KD-FTV ENGINE CONTROL>ECD SYSTEM(for DPF)>REGISTRATION) and initialization (See page Engine / Hybrid System>1KD-FTV ENGINE CONTROL>ECD SYSTEM(for DPF)>INITIALIZATION).
After replacing the fuel supply pump assembly, the ECM needs initialization (See page Engine / Hybrid System>1KD-FTV ENGINE CONTROL>ECD SYSTEM(for DPF)>INITIALIZATION).
After replacing an injector assembly, the ECM needs registration (See page Engine / Hybrid System>1KD-FTV ENGINE CONTROL>ECD SYSTEM(for DPF)>REGISTRATION).
Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Replace the ECM.
Click hereEngine / Hybrid System>1KD-FTV ENGINE CONTROL>ECM>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Clear the DTCs.
Click hereEngine / Hybrid System>1KD-FTV ENGINE CONTROL>ECD SYSTEM(for DPF)>DTC CHECK / CLEAR
Turn the ignition switch to ON and wait for 1 second or more.
Confirm that the DTC is not output again.
| Proceed to |
|---|
| NEXT |
NEXT