Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › 2012.04–2012.10
RM1840EF _54 Brake _009623 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0052601 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1337  Diameter of the Tire is not Uniform  


DESCRIPTION

The skid control ECU (brake actuator assembly) measures the speed of each wheel by receiving signals from the speed sensors. These signals are used for recognizing whether all 4 wheels are operating properly. Therefore, all wheel signals must indicate the same speed.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1337 Diameter of the Tire is not Uniform Either condition is met:
·

The diameter of the 2 front wheels is different from the diameter of the 2 rear wheels.

·

A wheel speed sensor is faulty.


·

Tire and wheel size

·

Tire deformation

·

Skid control rotor

·

Speed sensor

·

Speed sensor circuit

·

Skid control ECU (Brake actuator assembly)



CAUTION / NOTICE / HINT

NOTICE:

After replacing the brake actuator assembly, perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).


PROCEDURE

1.CHECK FOR DTC
a.

Check if any DTCs relating to the speed sensor circuit are output.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DIAGNOSTIC TROUBLE CODE CHART

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105
Result:
Result Proceed to
DTC is not output A
DTC is output B




A

2.CHECK TIRE SIZE

B

2.CHECK TIRE SIZE
a.

Check the tire size and condition of all 4 wheels.

OK:

All 4 tires are the same size and in the same condition.



Result:
Proceed to
OK
NG



OK

3.RECONFIRM DTC

NG

REPLACE TIRES SO THAT ALL 4 TIRES ARE SAME SIZE AND IN THE SAME CONDITION

3.RECONFIRM DTC
a.

Clear the DTC.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC > Clear DTCs
50002 105

b.

Turn the ignition switch off.


c.

Start the engine.


d.

Drive the vehicle at a speed of 30 km/h (18 mph) or more for at least 30 seconds.


e.

Check if the same DTC is output.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105
Result:
Result Proceed to
DTC is output A
DTC is not output B




A

B