The skid control ECU (brake actuator assembly) receives signals from the yaw rate sensor via the CAN communication system.
The yaw rate sensor assembly has a built-in acceleration sensor and detects the vehicle condition.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1442 | Invalid Data Received from Acceleration Sensor | With the IG1 terminal voltage between 9.5 and 17.4 V, an invalid data signal is transmitted continuously from the acceleration sensor for 10 seconds or more. | Acceleration sensor (Yaw rate sensor assembly) |
| C1443 | Invalid Data Received from Yaw Rate Sensor | With the IG1 terminal voltage between 9.5 and 17.4 V, an invalid data signal is transmitted continuously from the yaw rate sensor for 10 seconds or more. | Yaw rate sensor assembly |
After replacing the yaw rate sensor assembly, perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).
Clear the DTCs.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR
Turn the ignition switch off.
Start the engine and idle it for 60 seconds, and then stop the engine.
Check if the same DTC is output.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC is output | A |
| DTC is not output | B |
A
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>YAW RATE AND ACCELERATION SENSOR(w/ VSC)>REMOVAL
B
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING