If an ECM that is incompatible with the engine immobiliser system is installed, the ECM stores this DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| B279C | Theft Deterrent System Presence Detection | An ECM that is incompatible with the engine immobiliser system is installed (1 trip detection logic*). | ECM | Detection Enabling Condition (DTC Output Confirmation Operation)
Check for DTCs. |
*: Only output while a malfunction is present.
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
|---|---|
| Engine cannot be started. | - |
| DTC Code | Data List and Active Test |
|---|---|
| B279C | - |
When replacing the ECM, refer to the Service Bulletin.
After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.
Replace the current ECM with the proper ECM.
for 1KD-FTV:
Click hereEngine / Hybrid System>1KD-FTV ENGINE CONTROL>ECM>REMOVAL
for 2KD-FTV:
Click hereEngine / Hybrid System>2KD-FTV ENGINE CONTROL>ECM>REMOVAL
for 2TR-FE:
Click hereEngine / Hybrid System>2TR-FE ENGINE CONTROL>ECM>REMOVAL
for 2TR-FBE:
Click hereEngine / Hybrid System>2TR-FBE ENGINE CONTROL>ECM>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT