When the theft deterrent system is changed from the armed state to the alarm sounding state, the theft warning ECU assembly turns on the HORN relay, causing the vehicle horn to sound at 0.4 seconds intervals.
When replacing the theft warning ECU assembly, refer to the registration procedures (See page Vehicle Interior>DOOR LOCK>WIRELESS DOOR LOCK CONTROL SYSTEM(for Built-in Type Door Control Receiver)>REGISTRATION).
Press the horn switch and check if the horn sounds.
| Result | Proceed to |
|---|---|
| Horn sounds | A |
| Horn does not sound | B |
A
B
Disconnect the G29 theft warning ECU assembly connector.
Disconnect the 1I No. 1 integration relay connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G29-11 (HORN) - 1I-7 | Always | Below 1 Ω |
| G29-11 (HORN) or 1I-7 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG