Use these procedures to troubleshoot the blocking system.
*: Use the intelligent tester.
| Result |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Result |
|---|
| NEXT |
NEXT
Check that the engine cranks for more than 10 seconds.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for 2TR-FBE) | B |
| NG (for 1KD-FTV [w/o EGR Cooler]) | C |
| NG (for 1KD-FTV [w/ EGR Cooler]) | D |
| NG (for 1KD-FTV [for DPF]) | E |
| NG (for 1KD-FTV [for i-ART]) | F |
| NG (for 2KD-FTV [w/o EGR Cooler]) | G |
| NG (for 2KD-FTV [w/ EGR Cooler]) | H |
| NG (for 2KD-FTV [for DPF]) | I |
A
B
C
Click hereEngine / Hybrid System>1KD-FTV ENGINE CONTROL>ECD SYSTEM(w/ EGR Cooler)>PROBLEM SYMPTOMS TABLE
D
Click hereEngine / Hybrid System>1KD-FTV ENGINE CONTROL>ECD SYSTEM(w/o EGR Cooler)>PROBLEM SYMPTOMS TABLE
E
F
Click hereEngine / Hybrid System>1KD-FTV ENGINE CONTROL>ECD SYSTEM(for i-ART)>PROBLEM SYMPTOMS TABLE
G
Click hereEngine / Hybrid System>2KD-FTV ENGINE CONTROL>ECD SYSTEM(w/o EGR Cooler)>PROBLEM SYMPTOMS TABLE
H
Click hereEngine / Hybrid System>2KD-FTV ENGINE CONTROL>ECD SYSTEM(w/ EGR Cooler)>PROBLEM SYMPTOMS TABLE
I
Check for DTCs and note any codes that are output.
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>BLOCKING SYSTEM>DTC CHECK / CLEAR
Clear the DTCs.
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>BLOCKING SYSTEM>DTC CHECK / CLEAR
Based on the DTCs output above, try to force output of the same ECD system*1 or SFI system*2, engine immobiliser system and blocking system*3 DTCs by reproducing the monitoring conditions indicated by the DTCs.
*1: for 1KD-FTV, 2KD-FTV
*2: for 2TR-FBE
| Result | Proceed to |
|---|---|
| DTC is not output. | A |
| SFI system DTC is output (for 2TR-FBE) | B |
| ECD system (for 1KD-FTV [w/o EGR Cooler]) DTC is output | C |
| ECD system (for 1KD-FTV [w/ EGR Cooler]) DTC is output | D |
| ECD system (for 1KD-FTV [for DPF]) DTC is output | E |
| ECD system (for 1KD-FTV [for i-ART]) DTC is output | F |
| ECD system (for 2KD-FTV [w/o EGR Cooler]) DTC is output | G |
| ECD system (for 2KD-FTV [w/ EGR Cooler]) DTC is output | H |
| ECD system (for 2KD-FTV [for DPF]) DTC is output | I |
| Engine immobiliser system DTC is output | J |
| Blocking system DTC is output | K |
A
B
C
D
E
Click hereEngine / Hybrid System>1KD-FTV ENGINE CONTROL>ECD SYSTEM(for DPF)>DIAGNOSTIC TROUBLE CODE CHART
F
Click hereEngine / Hybrid System>1KD-FTV ENGINE CONTROL>ECD SYSTEM(for i-ART)>DIAGNOSTIC TROUBLE CODE CHART
G
H
I
Click hereEngine / Hybrid System>2KD-FTV ENGINE CONTROL>ECD SYSTEM(for DPF)>DIAGNOSTIC TROUBLE CODE CHART
J
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>BLOCKING SYSTEM>DIAGNOSTIC TROUBLE CODE CHART
K
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>BLOCKING SYSTEM>DIAGNOSTIC TROUBLE CODE CHART
Refer to Problem Symptoms Table.
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>BLOCKING SYSTEM>PROBLEM SYMPTOMS TABLE
| Result | Proceed to |
|---|---|
| Fault is not listed in the problem symptoms table. | A |
| Fault is listed in the problem symptoms table. | B |
A
B
Terminals of ECU.
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>BLOCKING SYSTEM>TERMINALS OF ECU
| Result |
|---|
| NEXT |
NEXT
When replacing the telephone transceiver assembly, instrument panel integration antenna assembly or mayday battery, refer to the Service Bulletin.
When the telephone transceiver assembly is replaced, it is necessary to set the contract mode.
When the mayday battery is replaced, it is necessary to register into the telephone transceiver.
| Result |
|---|
| NEXT |
NEXT
| Result |
|---|
| NEXT |
NEXT