Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › BLOCKING SYSTEM › from 2012.10
RM1840EF _58 Vehicle Interior _009641 THEFT DETERRENT / KEYLESS ENTRY _0052695 BLOCKING SYSTEM Y

THEFT DETERRENT / KEYLESS ENTRY  BLOCKING SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use these procedures to troubleshoot the blocking system.

·

*: Use the intelligent tester.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Result
NEXT



NEXT

2.INSPECT BATTERY VOLTAGE
2.INSPECT BATTERY VOLTAGE
Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result:
Result
NEXT



NEXT

3.CRANK ENGINE FOR MORE THAN 10 SECONDS
3.CRANK ENGINE FOR MORE THAN 10 SECONDS
a.

Check that the engine cranks for more than 10 seconds.

Result:
Result Proceed to
OK A
NG (for 2TR-FBE) B
NG (for 1KD-FTV [w/o EGR Cooler]) C
NG (for 1KD-FTV [w/ EGR Cooler]) D
NG (for 1KD-FTV [for DPF]) E
NG (for 1KD-FTV [for i-ART]) F
NG (for 2KD-FTV [w/o EGR Cooler]) G
NG (for 2KD-FTV [w/ EGR Cooler]) H
NG (for 2KD-FTV [for DPF]) I




A

4.CHECK FOR DTC*

B

C

D

E

F

G

H

I

4.CHECK FOR DTC*
a.

Check for DTCs and note any codes that are output.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>BLOCKING SYSTEM>DTC CHECK / CLEAR



c.

Based on the DTCs output above, try to force output of the same ECD system*1 or SFI system*2, engine immobiliser system and blocking system*3 DTCs by reproducing the monitoring conditions indicated by the DTCs.

*1: for 1KD-FTV, 2KD-FTV

*2: for 2TR-FBE



Result:
Result Proceed to
DTC is not output. A
SFI system DTC is output (for 2TR-FBE) B
ECD system (for 1KD-FTV [w/o EGR Cooler]) DTC is output C
ECD system (for 1KD-FTV [w/ EGR Cooler]) DTC is output D
ECD system (for 1KD-FTV [for DPF]) DTC is output E
ECD system (for 1KD-FTV [for i-ART]) DTC is output F
ECD system (for 2KD-FTV [w/o EGR Cooler]) DTC is output G
ECD system (for 2KD-FTV [w/ EGR Cooler]) DTC is output H
ECD system (for 2KD-FTV [for DPF]) DTC is output I
Engine immobiliser system DTC is output J
Blocking system DTC is output K



A

5.PROBLEM SYMPTOMS TABLE

B

C

D

E

F

G

H

I

J

K

5.PROBLEM SYMPTOMS TABLE
a.

Refer to Problem Symptoms Table.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>BLOCKING SYSTEM>PROBLEM SYMPTOMS TABLE

Result:
Result Proceed to
Fault is not listed in the problem symptoms table. A
Fault is listed in the problem symptoms table. B




A

6.OVERALL ANALYSIS AND TROUBLESHOOTING*

B

ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE

6.OVERALL ANALYSIS AND TROUBLESHOOTING*

NEXT

7.ADJUST, REPAIR OR REPLACE
7.ADJUST, REPAIR OR REPLACE
NOTICE:
·

When replacing the telephone transceiver assembly, instrument panel integration antenna assembly or mayday battery, refer to the Service Bulletin.

·

When the telephone transceiver assembly is replaced, it is necessary to set the contract mode.

·

When the mayday battery is replaced, it is necessary to register into the telephone transceiver.



Result:
Result
NEXT



NEXT

8.CONFIRMATION TEST
8.CONFIRMATION TEST
Result:
Result
NEXT



NEXT

END