Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER(for TSAM Made) › from 2013.10
RM1840EF _54 Brake _009624 BRAKE SYSTEM (OTHER) _0052621 BRAKE MASTER CYLINDER(for TSAM Made) A

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER(for TSAM Made)  INSTALLATION  


PROCEDURE

Hide 1.INSPECT AND ADJUST BRAKE BOOSTER PUSH ROD

Hide 2.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY

a.

Install a new O-ring to the master cylinder.


b.
C247715

Install the master cylinder and bracket (with 3-way) to the booster with the 2 nuts.

Torque:
12.5 N*m (127 kgf*cm, 9 ft.*lbf)


c.
C247714
2.156,0.375 2.313,0.573 0.156,0.198 10 true A 0.979,0.583 1.135,0.781 0.156,0.198 10 false B 1.615,0.99 1.771,1.188 0.156,0.198 10 true C 2.333,1.323 2.49,1.521 0.156,0.198 10 true C 1.5,1.479 1.656,1.677 0.156,0.198 10 true C 0.708,1.24 0.865,1.438 0.156,0.198 10 false C 0.688,1.885 0.844,2.083 0.156,0.198 10 true C

Using a union nut wrench, connect the 5 brake lines labeled C to the master cylinder and 3-way.

Torque:
15.2 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



d.

Connect the brake fluid level warning switch connector labeled B to the master cylinder.


e.

for Manual Transmission:

Connect the clutch reservoir tube labeled A to the master cylinder.


Hide 4.BLEED AIR FROM CLUTCH LINE (for Manual Transmission)