Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO RECEIVER › from 2013.10
RM1840EF _56 Audio / Visual / Telematics _009631 AUDIO / VIDEO _0052647 RADIO RECEIVER A

AUDIO / VIDEO  RADIO RECEIVER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Hide 4.REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (for Radio Receiver Type)

a.
E276853

Remove the 4 screws.


b.

Disconnect all the connectors and remove the radio receiver assembly with bracket.


c.

Detach the wire harness clamp.


d.
E278338

Disconnect all the connectors and remove the radio receiver assembly with bracket.


Hide 5.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for Radio and Display Type)

a.
E276854

Remove the 4 screws.


b.

Disconnect all the connectors and remove the radio and display receiver assembly with bracket.


c.

Detach the wire harness clamp.


d.
E278338

Disconnect all the connectors and remove the radio and display receiver assembly with bracket.


Hide 6.REMOVE NO. 1 RADIO BRACKET (for Radio Receiver Type)

a.
E276855

Remove the 3 screws and No. 1 radio bracket fromthe radio receiver assembly.


Hide 7.REMOVE NO. 1 RADIO RECEIVER BRACKET (for Radio and Display Type)

a.
E276857

Remove the 3 screws and No. 1 radio bracket from the radio and display receiver assembly.


Hide 8.REMOVE NO. 2 RADIO BRACKET (for Radio Receiver Type)

a.
E276856

Remove the 3 screws and No. 2 radio bracket from the radio receiver assembly.


Hide 9.REMOVE NO. 2 RADIO RECEIVER BRACKET (for Radio and Display Type)

a.
E276858

Remove the 3 screws and No. 2 radio bracket from the radio and display receiver assembly.