1.INSTALL NO. 2 RADIO RECEIVER BRACKET (for Radio and Display Type)
Remove the 3 screws and No. 2 radio bracket fromthe radio and display receiver assembly.
2.INSTALL NO. 2 RADIO BRACKET (for Radio Receiver Type)
Remove the 3 screws and No. 2 radio bracket from the radio receiver assembly.
3.INSTALL NO. 1 RADIO RECEIVER BRACKET (for Radio and Display Type)
Install the No. 1 radio bracket to the radio and display receiver assembly with the 3 screws.
4.INSTALL NO. 1 RADIO BRACKET (for Radio Receiver Type)
Install the No. 1 radio bracket to the radio receiver assembly with the 3 screws.
5.INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY (for Radio and Display Type)
Connect all the connectors.
Attach the wire harness clamp.
Insert the radio and display receiver assembly with bracket to attach the 2 clips on its backside.
When inserting the radio and display receiver assembly, do not press the knobs on it.
Install the radio and display receiver assembly with bracket with the 4 screws.
6.INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET (for Radio Receiver Type)
Connect all the connectors.
Attach the wire harness clamp.
Insert the radio receiver assembly with bracket to attach the 2 clips on its backside.
When inserting the radio receiver assembly, do not press the knobs on it.
Install the radio receiver assembly with bracket with the 4 screws.
7.INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Airbag System)
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).