Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION RECEIVER › from 2013.10
RM1840EF _56 Audio / Visual / Telematics _009632 NAVIGATION / MULTI INFO DISPLAY _0052659 NAVIGATION RECEIVER A

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION RECEIVER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Hide 4.REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET

a.
E276860

Remove the 4 screws.


b.

Pull out the navigation receiver assembly to detach the 2 clips on the back side of the navigation receiver assembly with bracket.


c.
E278338

Detach the wire harness clamp.


d.

Disconnect all the connectors and remove the navigation receiver assembly with bracket.


Hide 5.REMOVE NO. 1 RADIO BRACKET

a.
E276861

Remove the 3 screws and No. 1 radio bracket from the navigation receiver assembly.


Hide 6.REMOVE NO. 2 RADIO BRACKET

a.
E276862

Remove the 3 screws and No. 2 radio bracket from the navigation receiver assembly.