Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION RECEIVER › from 2013.10
RM1840EF _56 Audio / Visual / Telematics _009632 NAVIGATION / MULTI INFO DISPLAY _0052659 NAVIGATION RECEIVER A

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION RECEIVER  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).


PROCEDURE

Hide 1.INSTALL NO. 2 RADIO BRACKET

a.

Install the No. 2 radio bracket to the navigation receiver assembly with the 3 screws.


Hide 2.INSTALL NO. 1 RADIO BRACKET

a.

Install the No. 1 radio bracket to the navigation receiver assembly with the 3 screws.


Hide 3.INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET

a.

Connect all the connectors.


b.

Attach the wire harness clamp.


c.

Insert the navigation receiver assembly with bracket to attach the 2 clips on its backside.

NOTICE:

When inserting the navigation receivera ssembly, do not press the knobs on it.



d.

Install the navigation receiver assembly with bracket with the 4 screws.


Hide 4.INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).