Home › Engine / Hybrid System › 2TR-FE STARTING › STARTER(for 1.6 kW Type) › from 2013.10
RM1840EF _51 Engine / Hybrid System _009605 2TR-FE STARTING _0052434 STARTER(for 1.6 kW Type) A

2TR-FE STARTING  STARTER(for 1.6 kW Type)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL STARTER ASSEMBLY

a.

Temporarily install the starter with the bolt.


b.

Temporarily install the clutch flexible hose bracket with the bolt.


c.

Tighten the 2 bolts.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


d.

Connect the starter wire with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


e.

Connect the terminal cap.


f.

Connect the starter connector.


Hide 3.INSTALL FRONT FENDER SEAL

a.

Install the fender seal with the 5 clips.


Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).